Step 1 move the hardboard panels into the installation room and lean them up against the wall with the backs facing outward toward the room.
Installing white hardboard wall panel.
Leave the panels in this location for a minimum of 48 hours before installation to allow them to acclimate.
This is the.
For other options like our thrifty white smooth paneling you can quickly brighten up utility and laundry rooms.
Thrifty white panelboard is 1 8 in.
Stack the hardboard panels in the room where you plan to install them and leave them for 48 hours to allow them to acclimate.
Thick x 4 ft.
From an inside corner on a wall where you wish to start installing 4 foot wide panels.
When installing hardboard on the ceiling secure it firmly to the joists to prevent sagging.
Using a level mark a plumb line 48 in.
This will allow it to adjust to the humidity in a room.
If the corner isn t straight and plumb you ll see gaps.
Measure mark and cut the beadboard.
With our markerboard and frost white panels you can add a functional wall to draw and color on such as in workshops and playrooms.
How to install tempered hardboard panels to walls.
Use a stud sensor to locate and mark the wall framing.
Panel should end and begin on a stud.
The first step in how to install paneling is to remove all wall plates outlets and any nails in the wall.
In a conventionally framed room with wall studs 16 on center each 4x8 ft.
Installation is done using a high grade panel or construction trowel on adhesive.
Measure the height of the wall where you plan to install the hardboard panels using a tape measure.
Gently remove any crown moulding baseboards and trim you plan on using again.
After attaching the panel to the center stud insert additional nails through all remaining studs in the same manner.
Who says you can t draw on the walls.
Plan the installation to start at a left side corner and work outward across the wall to the right.
Insert 3 4 inch nails through the stud spacing them every 8 inches.
Tack a full panel in place with one long edge aligned with the plumb mark then check to see how the opposite edge fits into the corner.
It is not intended for use in a high moisture area like a shower or bathtub surround.