Don t see a hardware set that matches your exact door widths johnson track can be cut down to accommodate narrower doors by ordering the next longer track length hardware set for your door widths and cutting the track down.
Installing triple bypass sliding doors.
So i like to switch my bifold doors into bypass doors.
Commercial grade top hung sliding door hardware wall structure thickness varies with door thickness.
Do the same for the other side.
It s gonna cost about three hundred bucks for solid wood doors cheaper if you do hollow core the track is about fifty bucks for the hardware.
Thinner doors may have a wide gap between them.
400lbs 181kg max weight per door 6 1 2 165mm min wall structure thickness 1 1 8 29mm min door thickness 192 16 4877mm max.
The task is easier if you predrill the holes and use a drill bit on the drill to secure the screws.
Go ahead and mount the header board with 8 trim screws in each stud location.
Some minor variations exist among bypass door kits from different manufacturers but they are all easy to install.
In the case of bypass sliding doors you probably want your opening to be at minimum the width of the door opening.
The runner is what the wheels roll along so the door can slide back and forth.
This is an easy diy for anyone.
Insert the wheels on the top of the first door into the top track.
Using your level measure 2 above the door opening to locate the wall studs and secure your header board.
111md series sliding bypass door hardware.
Bifold doors look cheap and ugly and they always have a gap at the top they just don t look good.
Then latch the wheels on top of the door onto the back runner of the top track.
Once located drill pilot holes with a 1 8 drill bit in the top bolt location then drill with a 7 16 drill.
To install the doors install the track on the top of the door s frame.
This provides 1 2 inch of overlap between the two doors when they are closed.
Slide the bolt through the hole and mount the rolling hardware then drill the bottom hole.
The combined width of the doors should equal the width of the opening plus at least 1 inch.
Select a hardware set part number with track length that accommodates your door widths.