How To Straighten Auto Sheet Metal

The process of straightening metal is one that while seeming easy is actually a fairly difficult thing to do correctly.

How to straighten auto sheet metal.

They impart predictable and continuous curves to sheet metal. When straightening pipes fabricators sometimes fill the pipes with fine grained sand and close the ends of the pipes. Smaller scale pulling is commonly performed to remove dents where most of the displaced metal is locked out of position by a very small area of metal and where access. In order to counteract this stretch you have to be able to shrink the metal back to its original position.

It can be described much like an oil can lid. But they do remove metal making the panel thin in places and therefore affecting its strength and structure. The following is a 6 step method to help you repair those dents in no time at all. Using heat to facilitate the straightening of a modern automobile or light truck is very tempting.

How to straighten a panel. Slip rolls can also be set to put several different curvatures in the same panel and to flatten distorted metal. You will first need to pull out the dent in the sheet metal in order to straighten it. Automotive sheet metal starts out as a flat.

The reason for this is that metal tends to stretch when it is bent. Other tools used to straighten metal include tongs vices and clamps which hold the metal in place so the fabricator can move a part of the metal until it straightens. The condition known as an oil can is often encountered when performing automotive bodywork. This is made easier if you temporarily weld small metal rods to the damaged sheet metal using a rospot or a stud gun.

Get metal fab tools here.