How To Start First Row Of Vinyl Siding

For the remaining vinyl siding panels to be installed correct and level beginning with the lowest row you must install the starter strip correctly.

How to start first row of vinyl siding.

Cut a piece of flashing out of felt paper and install it at the bottom corners of the windows before you install the side j channels. You attach the bottom of the first row of siding to the top of this starter strip. But if the result is not a whole number you will need to cut the final piece of siding lengthwise in order to fill in. Installing vinyl siding in these 23 steps.

Overlap the flashing onto the row of siding just below the window. Get started installing vinyl siding with this video that covers wall preparation fasteners fastening techniques tools chalk lines corner posts and start. Now any water that runs inside the j channels will come out on top of the siding and out the weep holes designed for this purpose. If you have to cut the last row of siding you ll.

If the result is a whole number you re in. Just always make sure you leave room for expansion otherwise your siding will buckle and pop. This channel conceals. This chalk line should be level and a consistent distance from the eaves or the top and bottom of the windows.

As its name implies a starter strip is one of the initial steps during the installation of vinyl siding. Starting with the soffit nail lengths of j channel against the inner edge of the fascia board. Slot the vinyl siding into the lower siding and nail the top of the vinyl with 3d nails that match the color of the vinyl siding. This is where the new siding will begin.

Installing vinyl siding is really easy. Here is a website of mi. Because you cut away the channels at the top of the molding you must nail directly through the molding instead of placing the nails in the designated channels that you used in the rows below.