Ground Floor Concrete Floor Cross Section

Depending on the type of building construction or standards there are a number of methods for laying underfloor heating pipes in concrete floor structures.

Ground floor concrete floor cross section.

A typical way of constructing a solid floor would be to provide a base of hardcore with sand blinding with a layer of concrete over that. Part 3 of the build the concrete slab. Cross section of the substructure 12 dpm block work sand blinding ground level strip foundation. Light easy to work with cheap.

Floors shall be a minimum 3 1 2 inches 89 mm thick for expansive soils see section r403 1 8 the specified compressive strength of concrete shall be as set forth in section r402 2. This construction is suitable in reasonably stiff soils or marl. They can be insulated both underneath and on the edges. All hardcore should be compacted to refusal that is to the point where is will not compact any further this should be done using a mechanical compacter.

In concrete screeded floors the screed acts to diffuse the heat across the surface providing an even temperature at floor level. Concrete slab on ground floors shall be designed and constructed in accordance with the provisions of this section or aci 332. Types of suspended floors 27 timber joists pre cast concrete block beam advantages. Concrete floor in timber construction.

Solid ground floor suspended floor block and beam. There are three general types of ground floor construction. Concrete slab floors come in many forms and can be used to provide great thermal comfort and lifestyle advantages. Concrete ground floors consist of the following components in order.

To ensure a level finish to the floor a layer of screed is added over the top of the concrete which consists of sand and cement. Conventional concrete has high embodied energy. Ground level floor finish insulation site. The ground floor is made up of suspended concrete slab or beam and block floor supported by the external and internal load bearing walls which transfer the loads to the foundations below.

Ground floors there are two main types of ground floors. Concrete strip footing and concrete base with timber construction. Foundation cross section for concrete floor where we indicate insulation on the drawing we should point out that this must be to the specification shown by the architect if it is required. Both pre cast concrete planks or slabs can be used as well as cast in situ reinforced slabs along with beam and block systems.

Slabs can be on ground suspended or a mix of both. In this video we show how we prepared it and laid it. Section through a solid ground floor.